Driveway Cleaning, Sealing & Drainage in Romford
Pressure washing, resealing and drainage solutions for driveways, patios and paths across Romford and East London. Free quote, no money up front.
Restore and Protect Your Existing Surfaces
A driveway or patio that looks past it usually isn’t. Moss, algae, weeds in the joints and years of ingrained dirt make a good surface look tired long before it’s actually worn out, and a proper clean will often take years off it for a fraction of the cost of relaying.
We clean, reseal and re-sand driveways, patios, paths and terraces across Romford, Hornchurch, Upminster and the surrounding areas — whether we laid them or not.
Pressure Washing
Our petrol-driven pressure washers lift moss, lichen, algae, weeds and ingrained grime from block paving, slabs, concrete, tarmac and natural stone, bringing the original colour back out.
Algae in particular is worth dealing with before winter, as it turns genuinely slippery once it’s wet and it’s the most common cause of a fall on a domestic drive.
We work at the right pressure for the surface. Too much force will strip the face off soft sandstone or blow the jointing sand out of block paving, so we adjust to the material rather than blasting everything at full power.
Sealing and Re-Sanding
Once a surface is clean and dry, sealing it protects the work. A sealed drive resists oil and stain penetration, holds its colour against UV fade, and gives weeds and moss far less to root into. It also makes routine cleaning much easier.
On block paving we re-sand the joints first with kiln-dried sand, then seal, which stabilises the blocks and locks the whole surface together.
A seal typically lasts two to three years before it needs redoing. If you’d rather not seal, we’d recommend a clean once a year to stop moss establishing.
Drainage Solutions
Standing water on a driveway is a groundwork problem, not a weather problem. Water that sits in the middle of a drive, runs towards the house, or spills out onto the pavement means the falls or the drainage were never set up correctly. We install and repair:
- ACO and linear channel drainage across driveway entrances and thresholds
- Soakaways to take surface water safely away from the property
- Gullies, gratings and connections into existing systems
- Permeable surfacing and jointing that lets water through rather than off
- Land drainage for waterlogged lawns and gardens
We also unblock and clear blocked drains, gullies and pipework. If water is pooling somewhere it shouldn’t, come to us before it gets near the house — surface water running back towards a building causes far more expensive problems than it costs to divert.
How often should a driveway be cleaned?
Once a year if it isn’t sealed. Sealed surfaces can usually go two to three years between cleans.
Will pressure washing damage my block paving?
Not if it’s done at the right pressure. It will wash out the jointing sand, which is why we re-sand afterwards as standard — leaving the joints empty is what causes blocks to shift.
How long does sealing take to dry?
Usually a few hours before you can walk on it, and 24 hours before driving on it. We’d need a dry spell for the work, so we’ll book it around the weather.
Can you clean natural stone patios?
Yes, at a lower pressure than concrete or block. Sandstone and limestone are softer and will pit if they’re blasted, so they need a gentler approach and the right cleaning products.
Why is water pooling on my drive?
Almost always incorrect falls or no drainage outlet. Sometimes it’s a blocked gully that can be cleared in an hour; sometimes it needs a channel drain or soakaway installing. We’ll tell you which after a look.